Remorque porte-engins Fliegl ZTS 200 neuve

Description: Lowbed
Functionality: fully functional
Location: Oberpöllnitzer Straße 8, 07819 Triptis, Deutschland
Attention: The trailer may only be towed by towing vehicles that guarantee the effectiveness of the ABS!
Front area: steel floor
Country of registration: Germany
Note: Archive images!
Achsenkonfiguration: 2 axles
Customized Transport Solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are tailored to individual customer needs
Further Information
Chassis
Steel welded construction
Turntable with robust ball bearing race
storage box recessed in the turntable extension
Foldable rear support
Chocks with holder
Aluminum side impact protection
Splash guard at the rear over the entire width
Quarter panel fenders in front of the 1st axle
Spare wheel holder for 1 spare wheel
with wheel fastening kit
same brand as the standard tires
steel rim
Plastic toolbox
with insert
w=620/h=360/d=440 mm
lockable with a padlock. (Lock not included)
Tie-down points for low-loader
3 pairs of tie-down points
10 tons each
integrated in the floor at the front
6 pairs of tie-down eyes recessed in the upper and side parts of the outer frame
10 tons each
1 x at the neck area
the rest spaced out with a maximum distance of 1200 mm
1 x rear slope
5 pairs of ring tie-down points recessed in the outer frame
5 tons each (can be converted to stake pockets)
Coupling device
trailer
turntable
Drawbar with tested 40 mm drawbar eye
Axles and Suspension
SAF drum brake axles
Axle/chassis laser-aligned
reducing tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber mounting
Wheels and Tires
235 / 75 R 17,5
According to the manufacturer's choice
Steel rims in twin arrangement
factory silver
Braking System
Nebsi Ri Nxoyr Rbgyowk
2-line compressed air braking system
Spring brake parking brake
2 fail-safe coupling heads at the front
with connecting lines to the towing vehicle
ABS and ALB
with ABS plug at the front
with connecting cable
Voltage converter for 12/24 Volt operation
Note! A 7-pin socket
12 Volt
is required on the tractor/tow vehicle! (Required in conjunction with the voltage converter for electrical system!)
Electrical System
24 Volt
multi-chamber lights
yellow LED lighting on the sides
2 white/red position lights at the rear
2 white position lights at the front
Additional LED work lights at the rear
switched on via reversing light
2 x 7-pin fail-safe plugs at the front
with connecting cable
1 x 7-pin agricultural plug
Voltage converter 12/24 Volt (only for electrical system
not for ABS/EBS)
Floor
Then with 70 mm softwood floor
steel/non-slip sheet metal covering in the wheel arch area
Rear slope with 70 mm softwood floor
Low-loader platform including rear slope 8,200 mm
Loading Ramps
Steel ramps 2,800 mm long
750 mm wide
laterally movable
Covered with wood
With spring-assisted support
Operating Instructions
A special permit is required for an axle load of 10,000 kg. The permit must be applied for separately in each federal state
a guarantee for a 20-ton gross vehicle weight must not be given by the legislator. Customer risk
Country of Registration / Signs
With DEKRA inspection and certificate (according to §13 EG - FGV)
24/7 Service Hotline
Prepared for license plate holder
two-line
Contour marking with reflective tape according to ECE R 048
white on the sides and red at the rear
Paintwork
Frame DB 7350 Novagrau
10-year warranty against rust
Drawbar galvanized or black
according to manufacturer's choice
Loading ramps hot-dip galvanized